M
AINTENANCE
49
LIFTING THE VEHICLE
Read and comply with all of the following warnings and lifting procedures to prevent the
possibility of the vehicle falling and causing severe injury or death.
The vehicle must be on a firm and level surface for lifting.
Remain constantly aware that the vehicle is not stable during the lifting process.
Place the jack and jack stands only in the areas indicated in the following illustration.
Do not get under a vehicle until it’s stability on the jack stands is verified; never get
under a vehicle while it is on a jack only.
Put wheel chocks in front and behind all wheels that are not being lifted.
Do not allow anyone to remain or get on the vehicle at any time during the lifting process
or when the vehicle is lifted.
When performing any service to the drivetrain, lift all four wheels off the ground.
NOTICE: If the skid plate needs to be removed from the underside of the vehicle to perform maintenance,
remove it before lifting the vehicle.
Lifting Front
1.
Chock the rear wheels to keep the vehicle from roll-
ing backward.
2.
Put a jack under the center of the vehicle frame at
the differential mounting plate.
3.
Raise the vehicle with the jack.
4.
Install a jack stand under each side of the vehicle
frame just behind the front wheels.
5.
Lower the vehicle until it rests on the jack stands.
6.
Remove the jack.
7.
Confirm that the vehicle is stable on the jack stands
before proceeding with any service.
Lifting Rear
1.
Chock the front wheels to keep the vehicle from roll-
ing forward.
2.
Put a jack under the center of the vehicle frame at
the hitch mounting plate.
3.
Raise the vehicle with the jack.
4.
Install a jack stand under each side of the vehicle
frame just in front of the rear wheels.
5.
Lower the vehicle until it rests on the jack stands.
6.
Remove the jack.
7.
Confirm that the vehicle is stable on the jack stands
before proceeding with any service.
Lowering Vehicle
1.
Make sure chocks are still in place on any wheels
that remain on the ground.
2.
Put the jack in the same location that was used to raise the vehicle.
3.
Raise the vehicle enough to remove the jack stands. Remove the jack stands from underneath the vehicle.
4.
Slowly lower the vehicle to the ground and remove the jack.
Tools
• jack
• jack stands (4)
• wheel chocks
FRONT
REAR
Summary of Contents for Stampede 4x4
