O
PERATION
29
OPERATION
SAFETY
Failure to operate the vehicle correctly can result in a collision, loss of control, accident
or rollover, and cause serious injury or death. Read and comply with all safety warnings
in the safety section of this owner’s manual.
PRE-RIDE INSPECTION
Inspect and verify that the vehicle is in safe operating condition before each use to decrease the risk of an accident.
Check the items in the table to help ensure safe and reliable operation.
ENGINE BREAK-IN
Correct operation of the engine during the break-in period is essential to the performance, reliability and life of the
engine.
The engine break-in period is:
• the first 5 operating hours of a new engine
• the first 5 operating hours of an engine that has been completely disassembled
• the first few minutes until the engine is warm at each operation
During these break-in periods, operate the vehicle in the following manner:
• Avoid engine speeds over 6000 rpm.
• Avoid long periods of idle time.
• Avoid long operating times at low engine speed.
• Avoid long operating times at the same engine speed.
• Avoid long operating times with a full load.
• Vary the engine speed during operation.
• Apply quick bursts of acceleration after the engine has warmed up.
Item
Check
Page
Brake system/pedal travel
Check for proper operation.
Brake fluid
Check for correct level.
Park gear
Ensure vehicle does not roll when in park (P), and P light illuminates in the driver informa-
tion center.
Front suspension
Inspect. Lubricate if necessary. Check for loose or missing hardware.
Rear suspension
Inspect. Lubricate if necessary. Check for loose or missing hardware.
CV boots
Inspect for damage. Replace if necessary.
Steering
Check for smooth and free operation.
Tires
Check condition and pressure.
Wheel hardware
Check for loose or missing hardware.
Frame hardware
Check for loose or missing hardware.
Fuel and engine oil
Check for correct levels.
Coolant
Check for correct level.
Coolant hoses and radiator
Inspect for leaks.
Switches and indicator lights
Check operation.
Air filter
Inspect; clean or replace if necessary.
Headlights
Check operation.
Brake light / taillights
Check operation.
Seat belts
Check entire length of belt for damage. Check latch operation.
CVT belt
Check condition.
Summary of Contents for Stampede 4x4
