2.0/0908/TG
Page 4 of 6
STEP 1:
See PICTURE 1. Insert the SIXTEEN
BLACK PEGS (A) into the 16 peg holes on the ends
of the TWO TOP RAILS (B) and the SIX SHELF
RAILS (C1, C2).
Push the thinner end of the peg (as shown by
Part B) into the hole until the wider end is flush with
the wood (as shown on Part C).
PICTURE 3
D
B
C1
C2
C2
B
D
C1
C2
C2
PICTURE 2
STEP 2:
See PICTURE 2. Attach ONE TOP RAIL (B), ONE TOP SHELF RAIL (C1), and TWO MIDDLE/
LOWER SHELF RAILS (C2) to ONE END PANEL (D) using FOUR
1¾”
BOLTS (E).
Insert the black pegs on the RAILS (B, C) into their pre-drilled holes on the END PANEL (D) to line up
the other holes for the BOLTS (E).
The shelf grooves on the SHELF RAILS (C1, C2) should face in and line up with the shelf grooves on
the END PANEL (D).
STEP 3:
See PICTURE 3. Attach the second TOP RAIL (B) and the remaining THREE SHELF RAILS (C1,
C2) to the same END PANEL (D) using FOUR
1¾”
BOLTS (E).
PICTURE 1
B
C1,C2
A
A
*You must be sure to
use the C1 rails with
the thicker grooves
in the top positions.
