4.0B/0707/TG
Page 3 of 5
NOTE: Elegance
™
Round models should be assembled in the room where
you intend to use it unless your doorways are wider than 33” (83.8 cm).
These assembly instructions cover both Elegance
™
ROUND bassinets and Elite
™
OVAL
bassinets. The shape of the units is different but the parts and assembly steps are identical.
STEP 2:
See
PICTURE 2A (this page) and 2B (on page 3)
.
Locate the FOUR L-BRACKETS (F), EIGHT MEDIUM
BOLTS (G1), and EIGHT SHORT BOLTS (G2) so you can
bolt the BASSINET BODY (H) to the BASSINET STAND.
This step is easier if you put the bassinet body upside down,
and then put the bassinet stand upside down on top of the
bassinet body as shown in
PICTURE 2B
.
Line up the four pairs of holes on the END PANELS (A)
with the four pairs holes on the BASSINET BODY (H).
Position the L-BRACKETS (F) on the inside and secure them
using the EIGHT MEDIUM BOLTS (G1) for the end pan-
els, and the EIGHT SHORT BOLTS (G2) for the bassinet
body.
WARNING !
Once the bassinet stand is
assembled, do not disassemble
and reassemble for future use.
Doing so may affect the
stability and safety.
PICTURE 1B
A
B
A
D
B
PICTURE 1A
STEP 1:
See
PICTURES 1A and 1B
First, securely attach ONE CASTER WHEEL (E) to each leg of the END PANELS (A)
using ONE BOLT (E) and ONE KNOB (E) for each WHEEL (E). The knobs go on the
inside. The square hole on the wheel goes on the outside so the head of the bolt will “lock”
into the hole.
Next take ONE END PANEL (A) and attach the TWO RAILS (B) using TWO LONG
BOLTS (C). The grooves face inwards. Slide the SHELF (D) into the grooves with the
white warning label facing up. Then attach the second END PANEL (A) to the TWO
RAILS (B) using TWO LONG BOLTS (C).
PICTURE 2A
H
A
G2
G1
