12
WB26BCI STRAIGHT SHAFT TRIMMER & BRUSH CUTTER
4. Pull the starting cord again until the engine starts.
5. To begin trimming, press the lock lever down with your thumb and pull the throttle lever with
your fingers to increase power.
6. To adjust the line length while working: This trimmer is fitted with a “Bump-N-Feed” head. To
release more line, tap the cutting line head against the ground with engine at top speed. Line
will be released automatically and the knife on the blade guard will cut off the excess.
7. If any problems occur during operation, release the throttle lever and press the stop switch.
The machine will stop running.
8. If any problems occur during operation, release the shoulder harness by pulling the pin to
release the brush cutter immediately.
If the machine is still warm from running,
warm start
the engine as follows:
1. Move the throttle lever to the RUN position
2. Pull the starting cord to start the engine.
Before starting work,allow the engine running one minutes at idiling to warm up.
