Blancett B3100 Flow Monitor
Page 11
DSY-UM-02266-EN-02_B3100 Automatic Unit Converter Tutorial.docx
2.3 Set the reading for the flow rate
This chapter explains the procedure how to setup the measurement unit for reading the
B3100.
2.3.1 The flow rate - AUTO-VOL and AUTO MAS mode
This setting does not influence the K-Factor measurement unit as set from the flowmeter
certificate. The displayed measurement unit, as you selected, for the flow rate is calculated
from the settings in the flowmeter menu.
NOTICE
This procedure is only applicable for the automatic unit conversion modes
AUTO-VOL and AUTO-MASS.
ACTION
RESULT
N
OTICE
1.
Press the ►
button
until the FLOWRATE
menu shows.
•
The FLOWRATE menu
shows
Now you can set the FLOWRATE
settings, but not the K-Factor
(decimals) because these settings
are controlled by the FLOWMETER
settings.
2.
Press the ▲
button until
the UNIT menu shows.
•
The UNIT menu shows.
-
3. Press the PROG button
momentarily.
•
The PROG indicator
comes on.
Now you can set the measurement
unit for display purpose only..
4.
Press the ▲
button to
make the required
selection.
•
The selection US GAL
shows.
For the explanation,
the measurement unit for the flow
rate is set to US GAL.
5. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
The Flowmeter (K-factor) unit m
3
is
automatically converted to show the
total in US Gallons.
6.
Press the ▲
button until
the TIME menu shows.
•
The TIME menu shows.
-
7. Press the PROG button
momentarily.
•
The PROG indicator
comes on.
Now you can set the time unit for
display purpose only.
8. Press the
▲
button to
make the required
selection.
•
The selection /sec
shows.
For the explanation,
the time unit for the flow rate is set
to /sec.
9. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
The flow rate is shown in the
selected period of time.
10.
Press the ▲
button until
the DECIMALS menu
shows.
•
The DECIMALS menu
shows.
-
11. Press the PROG button
momentarily.
•
The PROG indicator
comes on.
Now you can set the decimal
pointer for display purposes only.
12. Press the
▲
button to
make the required
selection.
•
The selection 0.1 shows. For the explanation,
the decimals for the flow rate are
set to 1 decimal.
13. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
-
