Page 8
Blancett B3100 Flow Monitor
DSY-UM-02266-EN-02_B3100 Automatic Unit Converter Tutorial.docx
ACTION
RESULT
N
OTICE
12.
Press the ▲
button to
make the required
selection.
•
The selection US GAL
shows.
For the explanation,
the measurement unit for the
(accumulated) total is set to
US GAL.
13. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
The Flowmeter (K-factor) unit m
3
is
automatically converted to show the
total in US Gallons.
14.
Press the ▲
button until
the DECIMALS menu
shows.
•
The DECIMALS menu
shows.
-
15. Press the PROG button
momentarily.
•
The PROG indicator
comes on.
Now you can set the decimal
pointer for display purposes only.
16.
Press the ▲
button to
make the required
selection.
•
The selection 0.1 shows. For the explanation,
the decimals for the (accumulated)
total are set to 1 decimal.
17. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
-
NOTICE
The K-factor and the K-factor decimals for the (accumulated) total shows as
AUTO because the automatic unit conversion controls these parameters.
NOTICE
If 7 digits is not sufficient to show the (accumulated) total, you can multiply the
reading by x10, x100, etc. This multiplication factor is set in the next menu.
ACTION
RESULT
N
OTICE
18. Press the
▲
button until
the FACTOR X menu
shows.
•
The FACTOR X menu
shows.
-
19. Press the PROG button
momentarily.
•
The PROG indicator
comes on.
Now you can set the multiplication
factor for the (accumulated) total
which require more than 7 digits.
20. Press the
▲
button to
make the required
selection.
•
The selection 10 shows.
For the explanation,
the multiplication factor for the
(accumulated) total.is set to 10x.
21. Press the PROG button
momentarily.
•
The PROG indicator
goes off.
•
The selection is
confirmed.
-
