PROGRAMMING
Selection Screens
Press MENU while the normal display is shown to access the programming mode . In this mode, press one of the three arrow
keys (
) to select the option displayed above that key . On option list screens, use the arrows to scroll through a list of
choices, like a pull-down menu . Note that most screens presenting choices show three choices, one for each arrow button .
When the number of choices exceeds three, a small arrow (
) appears in the upper right side of the display to indicate more
choices on that level . Press ENTER to toggle to the next set of choices . Once a selection has been made, press ENTER to
complete the selection . Press MENU to return to the Normal screen . For example: Press MENU from the Normal screen to
display the “
RESET SETUP DIAG
” screen .
Press
to display the Reset screens,
to display the Setup screens and
to display the Diagnostic screens . If
is pressed,
the following screen appears:
6.1 Selection Screens
6.2 Option List Screens
6.3 Data Screens
SETUP
PWORD DSPY FLOW1
Menu Enter
Flow 1 units
GPM
Menu Enter
Set point
1.00000000
Menu Enter
Figure 13: Selection screen
Option List Screens
Units of measure is an example of an options list .
Press
to scroll up the list, and
to scroll down through the list . In this case, starting with GPM; gal/s; gal/hr; LPM; ending in
a selection of custom units . Press ENTER to complete the selection . Press MENU to leave the selection unchanged .
The
key has no function on this type of screen .
6.1 Selection Screens
6.2 Option List Screens
6.3 Data Screens
SETUP
PWORD DSPY FLOW1
Menu Enter
Flow 1 units
GPM
Menu Enter
Set point
1.00000000
Menu Enter
Figure 14: Options list screen
Data Entry Screens
Some screens are data entry screens, such as setpoints or custom units . When a data screen is initially displayed, the current
value will be displayed . The cursor will be flashing the left-most digit . Press
to increase a value, and
to reduce a value .
If the cursor is flashing on the decimal point, press
to move the decimal point to the right, press
to move the decimal to
the left .
6.1 Selection Screens
6.2 Option List Screens
6.3 Data Screens
SETUP
PWORD DSPY FLOW1
Menu Enter
Flow 1 units
GPM
Menu Enter
Set point
1.00000000
Menu Enter
Figure 15: Data entry screen
Programming
Page 14
October 2017
CTL-UM-01026-EN-05
