ESM-UM-03099-EN-02
BEACON FIRST TIME SETUP
For meters connected to ORION Cellular LTE-M, LTE-MS or LTE endpoints, perform these steps to make sure the E-Series
Ultrasonic meter sensor information is accessible in BEACON
1 In BEACON, select the
Assets
tab Then select
Utility Settings
from the menu on the left
Figure 1: BEACON Assets
2 On the Utility Settings page, scroll down to the
Monitor Page Filters
section and find the
Sensors
section
Figure 2: Water Pressure and Temperature sensors selection
3 Select the
Water Pressure
and/or
Water Temperature
check boxes to turn on reporting for the temperature and/or
pressure meter sensors
4 Select
Update Utility
at the bottom of the page
to save your changes
Figure 3: Save changes
5 Select the
At A Glance
tab and click
Add/Remove
on the right side of the page below the main tabs menu
6 On the window that opens, select
Add
for
Water Pressure Health
and
Water Temperature Health
Then select
Done
Water Pressure Health
and
Water
Temperature
Health
modules now display on the
At A Glance
page
Setup is complete
Requirements
Page 4
May 2021
