Commissioning
Seite 18
December 2019
AC_F001_IA_02_2243
5.4. How to set setup menu authorization
This procedure is used to set a pin code to protect the setupmenu for unauthorized access. The pin code has no influence on
the operator menus.
Action
Result
Remark
1. Press the SELECT key, for at least 7
seconds.
•
The SETUP indicator comes on
continuously.
•
The setup menu TOTAL shows.
The SETUP indicator starts to flash when you
enter the setup menu.
2. Press the CLEAR key, to find the main
menu: OTHER.
•
The SETUP indicator stays on
continuously.
•
The submenu shows: OTHER.
Press the SELECT key as many times as
applicable.
3. Press the SELECT key, to find the
submenu: PIN.
•
The SETUP indicator stays on
continuously.
•
The submenu shows: PIN.
You can set any 4 digit numerical value.
4. Short and simultaneously, press the
SELECT and CLEAR key to access the
submenu: PIN.
•
The PROG indicator blinks
continuously.
If you wait too long, the program mode
goes off and changes are not saved, this is
normal behavior.
5. Use the SELECT key to increase the
digit. Use the CLEAR key to go to the
next number.
•
The PROG indicator blinks
continuously.
•
You can set the required pin code.
The pin code 0000 disables the pin code to
allow for access by any person.
6. Short and simultaneously, press the
SELECT and CLEAR key to confirm the
selection.
•
The PROG indicator goes off.
•
The selection is saved.
•
The display shows the selected
engineering unit.
If you do not press the SELECT and CLEAR
key short and simultaneously to confirm,
your selection is not saved.
7. Press the SELECT key, to return to the
main menu: OTHER.
•
The SETUP indicator stays on
continuously.
•
The setup menu OTHER shows.
-
8. Press the SELECT key, to review
the settings you made. Make any
corrections as necessary.
•
The SETUP indicator stays on
continuously.
•
Each submenu shows the selected
parameter.
This step is used to verify the saved value for
each setting.
Press the SELECT key as many times as
applicable.
9. When in the main menu: OTHER, press
and hold the START key, for at least 3
seconds.
•
The SETUP indicator goes off.
•
The RUN indicator comes on.
•
The operator menu shows.
The F001 is ready for daily use.
