General description
Seite 6
December 2019
AC_F001_IA_02_2243
WARNING
DO NOT TUNE THE OUTPUT IF A PROCESS IS ACTIVE. UNWANTED RESULTS WILL OCCUR IF YOU TUNE THE F001 WHEN
THE ANALOG OUTPUT IS IN USE. UNWANTED RESULTS CAN RESULT IN (SERIOUS) DAMAGE TO EQUIPMENT.
OTE:
N
If required, you can program the analog output up-side-down. In other words the minimum current
represents the 20 mA signal and the maximum current represents the 4 mA signal.
4.4
t.min
The minimum analog output is set to 4 mA (as a default). However, as a result of the ambeint
conditions, this value might need a correction for the actual situation. This submenu is used to set
a correction for the minimum signal (4 mA).
4.5
t.max
The maximum analog output is set to 20 mA (as a default). However, as a result of the ambient
conditions, this value might need a correction for the actual situation. This submenu is used to set
a correction for the maximum signal (20 mA).
5. D-OUT
5.1
mode
This submenu is used to disable or to set a pulse output length. Short represents a puls length of
10 ms (maximum), Long represents a pulse length of 100 ms (maximum).
5.2
decs
This submenu is used to set the amount of digits behind the decimal pointer for the quantity
(amnt).
5.3
amnt
This submenu is used to set the quantity of a medium that has passed the sensor (is added to the
total) to generate a pulse. In other words, the quantity that represents one pulse.
For support and maintenance it is important to have information about the characteristics of the F001. Your supplier will ask
for this information when support is required.
6. Other
6.1
modl
This submenu shows the model name. The model name is set by the factory.
6.2
v-no
This submenu shows the version number of the firmware (software). The version number is set by
the factory.
6.3
s-no
This submenu shows the serial number of the F001. The serial number is set by the factory.
6.4
pin
This submenu is used to set a password (pin code) to limit the access for the setup menu. Only
persons who know the pin code can access the setup menu. The pin code 0000 disables the pin
code to allow for access by any person.
6.5
bl
This submenu is used to set the backlight. Due to lack of sufficient power, the backlight does not
come on at battery power only.
3.5. Navigation
This sections describes how to navigate through the setup menu.
The setup menu has different menus and pages to configure the
F001. For navigation, the menus and pages are identified with
main menu numbers (e.g. 1) and submenu numbers (e.g. 1.2).
•
Enter the setup menu: Press the SELECT key, for at least 7
seconds.
•
Select a main menu: Press the CLEAR key, to find the
required main menu.
•
Select submenu (setting): Press the SELECT key, to find the required submenu.
•
Enter a submenu to make a selection: Short and simultaneously, press the SELECT and CLEAR key to access the submenu.
