Register programming
October 2019
AC_ILR_BA_02_1632
Page 7
1.
Press the
RESET
button to toggle between available options (“I, for an inline-to-flow orientation and “P” for a perpendicular-
to-flow orientation or “o” for Remote versions and for the RCDL-nutating disc meters and the Vision turbine meters).
2.
When finished adjusting the register orientation, press and hold the TOTAL button for one second to advance to the “Default
Display” section.
3.5
Changing the display mode (for all ILR models with display)
The display mode screen (indicated by a “d” on the top row, on the left side) determines the information displayed on the top
line of the register during normal operation. The display mode may be either the totalizer screen or the flow rate screen.
“C,” indicates the totalizer screen and “F” indicates the flow rate screen. The totalizer screen is depicted below:
Default display
1.
While a letter is flashing on the display, press the
RESET
button to select either totalizer or flow rate.
2.
Upon completion of this setting, the programming of the industrial standard register and the industrial dual pulse output
is complete. For ILR701, ILR701T, ILR750 and ILR750T models, see additional programming parameters.
3.6
Exiting programming mode (for all ILR models with display)
To exit the programing mode:
1.
On any screen, press and hold the both the TOTAL and RESET buttons. The
screen will revert back to the
programmed scale factor, and then flash. Following the three flashes, the register display will be blank.
NOTE:
Pressing the TOTAL or RESET buttons will turn the display back on.
