9
Step 3:
Be sure the gas INLET markings are
on the same side of the meter and the lens
faces forward.
Gas INLET
markings
Lens facing
forward
Step 4:
Place the American Index and cover
plate (removed earlier) back on the
Badger
®
ORION
®
transmitter.
Place it so the text;
TURBINE FRONT FLOW
AL-600, AL-1000, AL-1400, AL-2300, and
AL-5000 (or other such text)
; faces the front
and the index hole is centered around the
transmitter drive pawl.
Place the index drive
pawl perpendicular to
the transmitter drive
pawl.
Step 5:
Place two screws, with a washer on
each, into two corners of the cover mounting
plate.
Use four (4) 18-18x3-1/2 supplied mounting
screws to attach the index, cover plate, and
Badger ORION transmitter to the gas meter.
Washer
Step 7:
Tighten all screws evenly with a large
screwdriver to approximately 70 inch lbs.
Step 6:
Index and cover has two platic seal
caps that are difficult to maneuver around with
the long bolts. Place two of the screws,
without washers, through the white seal caps.
Place them in the other opposite corners of
the cover mounting plate.
Program the Badger ORION Transmitter
Badger uses the Radix
®
system to display
and process screens.
Place the Radix so the optic read head aligns
with the LED output port. The angle of
approach should be about 30 degrees.
Rotate Radix unit to
about 30 degrees
Radix
4
3
30
°
