10
11. Use the keypad to enter Transmitter
Serial Number into the Odometer Entry
box.
NOTE:
Do not enter the leading 7 of the
Transmitter Serial Number.
12. Again, place the Badger
®
-Radix
®
unit over
the Programming Accessory.
13. Select [Set Odometer] <O>.
14. Remove the Badger-Radix from the
Programming Accessory.
15. Swipe the programming magnet over
the bottom right corner of the ORION
®
Repeater to put the unit into
programming mode. Once the ORION
Repeater has been put into
programming mode, it will listen for a
signal from the Programming Accessory
for up to 16 seconds. Once it
successfully hears the Programming
Accessory signal, the ORION Repeater
will verify it has been successfully
programmed by continuously
broadcasting the ORION transmitter
reading for one minute.
