Page 16
For technical questions, please call 1-800-444-3353.
ATV Winch
Operation
Read the ENTIRE IPORTANT SAFETY
INFORATION section at the beginning
of this manual including all text under
subheadings therein before set up or
use of this product.
The instructions that follow are basic
guidelines only and cannot cover all
situations encountered during use. The
operator and assistants must carefully
plan usage to prevent accidents.
Clutch Operation
ITE 68146, 2000 lb. Winch:
1. The position of the pin in the shaft determines
whether the clutch is engaged or not.
Shaft
Pin
Drum
End
If the pin rests
in the groove in the drum
the clutch is
engaged
.
Shaft
Pin
Drum
End
If the pin rests
on top of the end of the drum
the clutch is
released
.
2. To change clutch positions (see Figure G):
a. Pull clutch knob out.
b. Turn it 90° while it is pulled out, then release it.
a
b
FIGURE G — 68146 CLUTCH OPERATION
ITE 68145, 3000 lb. Winch and
ITE 68144, 5000 lb. Winch:
CAUTION: Do not adjust the clutch unless
there is no load on the wire rope.
1. To engage the clutch, turn the Clutch Knob
clockwise completely until it stops, see Figure H.
2. To release the clutch (freespool), turn the
Clutch Knob counterclockwise completely
until it stops, see Figure H.
FIGURE H — 68145, 68144 CLUTCH OPERATION
Engage
Release
(freespool)
REV 10l
Brought to You by www.snapwhole.com
