Page 4
For technical questions, please call 1-888-866-5797.
Item 56412
Installing Synthetic Rope Through Drum Hole
1. Slide heat shrink tube toward the
red heat sleeve to expose the full
splice. Remove 1 inch of heat
shrink tube from loop side of Rope if
necessary to facilitate movement.
Heat Shrink Tube
Splice Exposed
2. Loosen splice to identify Inner and Outer
rope fibers at the base of the splice.
Inner Fibers
Outer Fibers
3. Pull the Inner fibers out where
they enter the center of the Outer
fibers and fully remove them.
Inner Fibers
Outer Fibers
Inner Fibers
Removed
4. Wrap the end of the Rope with
tape to stabilize the fibers.
Wrap Rope
with Tape
5. Undo the original loop until a
single opening is left in the Rope.
Orient the opening as shown and
pass the taped end of the Rope
through the hole to close it.
Taped End
of Rope
