BaehrTec A2000 operating instructions
English – V101 - effective 10/13
Page 35/58
For cleaning, we recommend the Baehr cloths Art. No. 11000.
5) Push the dust bag carefully with the opening on the receptacle
(39),
until the
(cardboard) reinforcement of the dust bag locks into the slot on the dust bag lid.
Make sure that you do not damage the dust bag when sliding it on and that
you do not bend the seams.
6)
Place the dust bag lid back on the controller (see section
“Disconnecting /
connecting the dust bag lid to the controller”).
4.9.2
Changing the turbine protection filter
The turbine protection filter and all other filters must be replaced immediately
if you have been working with your BaehrTec A2000 without a dust bag (if
you forgot) or if a dust bag has burst.
To change the turbine protection filter, please proceed as follows:
1)
Turn off the device at the main switch and disconnect it from the power supply.
2)
Disconnect the dust bag lid from the controller (see section
“Disconnecting/connecting
the dust bag lid to the controller”
).
3)
Remove the old turbine protection filter from the suction chamber.
4)
Clean the suction chamber, the dust bag lid, the grille and the magnetic fasteners on
the controller and the dust bag lid during each filter change.
For cleaning, we recommend the Baehr cloths Art. No. 11000.
5)
Place a
new turbine protection filter on the grille.
