BaehrTec A2000 operating instructions
English – V101 - effective 10/13
Page 39/58
7)
Attach the knurled screws and position the filter cassette on the controller. Turn the
knurled screws clockwise until you feel a slight resistance.
Fig. 21
Warning! Please do not turn the knurled screws too far or overtighten them.
4.10
Start-up
1. Make sure that there is a dust bag in your BaehrTec A2000. To do this, you must
disconnect the dust bag lid from the controller (see section
“Disconnecting/connecting the
dust bag lid to the controller”
). On the receptacle
(39)
on the inside of the dust bag lid, a
dust bag is pushed on as far as the stop. In addition, the turbine protection filter is
located in the suction chamber. If everything is in order, connect the dust bag lid back
onto the controller (see section
“Disconnecting” / “connecting the dust bag lid to the
controller”).
If the dust bag is missing, you must insert a new dust bag before working
with the device (see section
“Changing the dust bag”
). Now connect the dust bag lid back
onto the controller (see section
“Disconnecting/connecting the dust bag lid to the
controller”
).
2. Please ensure that the device has a secure footing, does not fall down and cannot be
torn down, and that the extracted air can escape easily. Turn the main power switch
(3)
off.
3.
Plug the supplied device connection cable
(57)
with the device connector
(56)
into the
device socket
(46).
4.
Plug the Schuko plug
(58)
into a proper Schuko socket.
5. Now, turn on the BaehrTec A2000 at the main switch
(3)
. After a short LED check, the
“Power ON” LED
(4)
and the LED for the largest instrument (6,000 rpm)
(5)
will light
up.
The following things are set after each power on:
o
Handpiece motor rotation direction = clockwise
o
Handpiece speed = 6,000 rpm (LED lights up)
o
Handpiece motor = OFF
o
Suction level = 4+
o
Suction = ready for operation
o
Suction = off (as handpiece motor = off)
