1394/USB Combo hard disk Enclosure User’s Manual 27
7.11
MAC un-installation
7.11.1 Throw the “
BAFO USB-ATA/ATAPI Bus” “BAFO USB-ATA/ATAPI Shim”
“BAFO USB-ATA/ATAPI USB”
these three files to the trash can, and
restart your computer again.
8
FAQ
Q :
The “Add New Hardware Wizard” or “Found New Hardware Wizard” dialog box
does not show up.
A :
When plug -in IEEE1394, this dialog won’t show up. Only plug-in USB this dialog
box will appear. Please check following items.
i). Power indicator on?
Make sure power adaptor properly plug in power socket and power switch
has been turn on.
ii). Plug out USB cable first and turn power switch off then on before p lug in USB
cable again.
iii). Make sure USB plug be inserted into enclosure USB connector properly
iv). Does computer and enclosure has been connected by 1394 cable?
IEEE1394 and USB can’t be used simultaneous.
v). Driver of USB has been normally installed? Please refer to driver installation.
Q :
After driver installed, there is no new hard disk model name show at “Disk
Drivers” of “Device Manager” or “Universal Serial Bus controllers” does not have
“BAFO USB-ATA/ATAPI Bridge Controller” or “?” appear.
A:
Adjust jumper of hard disk to “Cable Select” or other setting and try again.
Q :
If a brand new hard disk has been installed at enclosure. It shows “BAFO
USB-ATA/ATAPI Bridge controller” in “Universal Serial Bus controllers” ,but
there is not any new hard disk at “Disk drivers”.
A :
Please
FDISK
and
FORMAT
hard disk.
Q :
In Windows
®
, system will down when plug out IEEE1394 cable.
A :
You can install the Windows
®
98 Second Edition 1394 Storage Supplement on a
computer running Windows
®
98 Second Edition from “Recommended Updates”
section of the following Microsoft Windows Update Web site
http://windowsupdate.microsoft.com
You can also download this update from the following Microsoft Web site
http://www.microsoft.com/windows98/downloads/contents/WUCritical/1394/Default.asp
