Bag of Ice XL1900, Product Manual

26

b.  Lift away 

RemovethetopStyrofoamandplasticcovers�

c.  Remove black 

thumbscrew

 and remove the front cover.

4.  Turn ice maker 

ControlSwitch

 to the OFF position.

                  The 

ControlSwitch

 is located at the bottom of the 

ControlBox

 on the upper right side of the ice maker. 

5.  Pour the required amount (suggested by manufacture for 5 gallons) of 

scaleremoverfor

 into the 5 gallon 

bucket, and fill to within 4 inches of the top with water using the hose access at your sink.

6.  Pour the other half of the 

scaleremover

 into the ice maker reservoir.

7.  Turn ice maker 

ControlSwitch

 to the 

WASH

 position - Keep in the Wash position for at least 1 hour (

ifyou

havenotcleanedyouricemakerregularlyyoumayneedto
washforalongerperiodoftime

)

8.  Return ice maker 

ControlSwitch

 to the 

OFF

position.

9.  Disassemble ice plate assembly.  
10. Remove the black hoses from the 

flowtubes

- 

heldinplacewithasnap-fitlockthatcanbereleasedby

gentlysqueezing�

    a. Pull out 

flowtubes

 by angling downward.

    b. Place in the cleaning bucket after you remove.
10. Remove the plastic 

waterguides

on top of the

ice

platechannels

 and 

place in the bucket.

11. Clean each groove of the 

iceplates

using an 

Elongatedcleaningbrushes

. 

Take care not to scratch the 

IceMakingPlates

as this can cause 

ice to stick to the 

IceMakingPlates

during ice 

production.

12. Remove the 

plasticcap

 at the bottom of the 

Float valve to verify that the 

floatValve

 is not 

sticking. If the 

FloatValve

 is sticking, remove, 

clean, and place in the bucket.  

Make sure 

you keep the power connector dry

. The 

power connects into the 

icemakercontrolboard

. 

Both the connector and the 

controlboard

connector

 are black .

13. Clean the 

icemakingplatechannels

 with the 

elongatedcleaningbrushes

 and 

3/16”stainlesssteelrod

and a toothpick, rinse and replace.

a.  Use a 3/16” stainless steel rod to 

scrape residue in the small return 

tube.

b.  Use toothpick to insure that all the holes are open and clear.

14. Clean Solenoid Screen 
    a. Remove screws from the Solenoid Housing

Float Valve

Remove plastic cap

Keep power connector dry

Styrofoam cover

Plactic cover

Remove plastic cover

Hoses &  flow tubes

Disconnect hoses

Flow Tubes

Remove at an angle

Water Guides