Air suction device
–
User manual
Page 14
of 28
UMN Air 10/2019
Buttons explained:
Hand piece motor OFF:
When this button is grey, it indicates the hand piece motor is switched off. In suction mode, the
hand piece motor off status automatically ensures the suction function is switched off. It turns on
again, as soon as the hand piece motor is switched on.
An orange button indicates that the hand piece motor is turned on. The hand piece motor can
only be switched on using the button on the hand piece itself.
Nail drill light ON/OFF
The LED lighting for the nail drill works both when the hand piece motor is running and
deactivated. It is operated solely via the ON/OFF button in the app.
When orange, this button indicates that the LED lighting is activated.
Do not look directly into the beam of the LED lighting! Danger of retinal burns!
Hand piece motor - speed
—
This button reduces the speed of the hand piece motor. The lowest speed setting is 3,000 rpm.
The speed can be reduced in increments of 1,000 rpm.
Hand piece motor - speed +
This button increases the speed of the hand piece motor. The highest speed setting is 42,000
rpm. The speed can be increased in increments of 1,000 rpm.
Hand piece motor - speed slider
This slider allows you to swiftly set your desired speed. It ranges from the minimum speed of
3,000 rpm up to the maximum speed of 42,000 rpm. This occurs in increments of 1,000 rpm.
Please always observe the maximum speed specified by the manufacturer of the nail drill
bit you are currently using. Do not exceed this speed under any circumstances! You could
endanger yourself and your client.
Changing direction of rotation
Pressing this button changes the direction of rotation of the hand piece motor. Anti-clockwise
becomes clockwise and vice versa.
When orange, this button indicates that the hand piece motor is active.
Preset buttons A to D
These buttons enable you to save your preferred motor speed and suction power settings for later
use.
An orange letter indicates that the pre-set speed and suction power saved under the letter have
been activated. The values set will appear in the respective speed and suction power fields on
the screen.
