Air suction device
–
User manual
UMN Air 10/2019
Page 19
of 28
To start the process of teaching the handpiece, two safety precautions are necessary:
• The milling cutter must be removed from the handpiece.
• The handpiece must be sec
ured against falling
These safety precautions require the handpiece to switch on and off automatically during the teach-in process.
Different speeds of rotation are tested in this phase. This process takes about 1-2 minutes.
The app will notify you when the process is complete. You can then use the app and foot care device as usual.
The foot care device cannot be operated while teaching the handpiece.
9.8.6. Contact
This menu item displays the contact details of Bahner Feinwerktechnik GmbH.
You can also call the manufacturer directly by clicking on the phone number. This requires an activated SIM card
in the smartphone.
By clicking on Contact Form you will be forwarded directly to the contact form of our website
. An internet connection is required to contact us via the contact form.
9.8.7. Info
In the Info section you will find all information about the b-on-foot Air device and the installed app.
In the event you require technical support, please note all the relevant details regarding your foot care device and
pass this information on to the customer service department at Bahner Feinwerktechnik GmbH. Information such
as the app version, hardware version, software version and serial number will help us process your enquiry faster,
better and more effectively.
9.8.8. Data protection
You can read Bahner Feinwerktechnik
GmbH’s
Privacy Policy under this menu item.
You will need an active internet connection to view the Privacy Policy. The latest version of the Privacy Policy is
available under the link
https://www.b-on-foot.de/datenschutzerklaerung/
9.8.9. Dust bag change
The dust bag of the device must be replaced when the dust bag is full or when the suction power not more.
Open the dust box cover by pulling the hose manifold up and away from the unit, slightly forward and down. Then
the dust bag, complete with the dust box lid, is carefully pulled out of the device.
Now pull off the full dust bag from the cable suction tube.
You should wear a mouth and nose protection, the sanding residue can be hazardous to health
his!
Every time the dust bag is changed, the suction manifold on the lid of the dust box should be freed from any
deposits.
To avoid damage to the cables inside the opening, use the
