Air suction device
–
User manual
UMN Air 10/2019
Page 5
of 28
2. Symbols used in this manual
On the device nameplate:
Consult instructions for use
Indicates the product is CE certified
Waste disposal marking for electrical and electronic equipment according to § 7 ElektroG
Applied parts classified as Type BF (body floating - floating denotes isolation from earth)
IPXO
No special ingress protection against moisture (IP = International Protection).
In the user manual:
This symbol indicates special instructions that must be carefully followed to prevent injuries or
damage. These instructions are intended for occupational safety.
This symbol indicates important instructions for compliance with regulations or where there is
a risk of damage to the device.
Warning of optical radiation
3. Package contents
The following items are included in the product box:
1 x
Suction device with attached motor hand piece
1 x
Power cable
1 x
Service pack including extraction tool
1 x
Spare dust bag
1 x
Installation guide - APP
1 x
TP-Link Neffos C9s multifunction smartphone,
including charger and protective cover
If any of these items are missing, please contact your supplier immediately to request the missing item(s).
Please keep the box in which the Air suction device was shipped to you, including the protective
padding. In case of replacement or repair, the original packaging must be used when returning
the item. Please note that Bahner Feinwerktechnik GmbH accepts no responsibility for any
damage caused as a result of failure to comply with this instruction.
