Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide
30
4.
Initial Configuration
4.1 Configure Basic Parameters
After installing and testing the Aurora243 gNB, Baicells recommends configuring the gNB without enabling
HaloB or SAS to verify that the new eNB unit is operational. Once it is confirmed to be operational, you
can refer to the appropriate configuration guide(s) for the operating mode you plan to use.
NOTE: For all GUI menus and fields, refer to the following documents on the Baicells website:
•
CloudCore Configuration & Network Administration Guide (OMC/BOSS)
•
CPE Configuration Guides
4.1.1.1 Network Connection Requirements
Before initial configuration, verify that the following network connections of Aurora243 gNB, as shown in
(Figure 4-1) are connected successfully.
•
Aurora243 gNB connects to the core network through the optical backhaul interface (
OPT
).
•
ETH
interface is the management port used for debugging.
•
The
ANT0
and
ANT1
ports must be connected to the external RF antennas.
•
Connect the
GPS
interface to the external GPS antenna.
Figure 4-1: Network Connection
