Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide
34
4.1.5 Configure Parameters
After upgrading the gNB to the recent firmware version, log in to the gNB GUI and configure related
parameters to bring up the gNB online.
4.1.5.1 Configure CU and DU IP Addresses
Configure the CU and DU loopback IP address as 127.0.0.X. The
NGAP Local IP
and
Egtpu Local IP
of
the CU should be the same network segment as the
AMF IP
of the core network.
1.
Go to
NR Setting > Advanced
. Then, under the
CU
pane, configure the CU IP address.
2.
Configure the loopback IP address of CU in the
F1ap Local IP
and
F1U IP
field as 127.0.0.X.
3.
Click the
+ Add
icon in the
AMF IP
field to enter the
AMF IP
address and the
NGAP Local IP
address.
Figure 4-6: Configure the IP address of CU
4.
Go to
NR Setting > Advanced
. Click the
DU
pane to open the fields and configure the DU IP address.
5.
Enter the loopback IP address of the CU in the
DU F1C Remote IP
field.
6.
Enter the loopback IP address of DU in the
DU F1AP Local IP
and
DU F1U Local IP
fields.
7.
Click the
Save
button.
