14
Figure 3-12 Connect Cable 2
3. Connect to POE power.
One end of the cable connect to CPE and the other end connect to POE power. Fix
the cable on the pole using plastic tie close to CPE about 20cm, preventing the
damage of the cable waggling with the wind.
It is recommended that the cable is fixed by plastic tie at intervals of 50cm until POE
power. If the length of outdoor is too long, you need to protect the cable with metal
shielded flexible sleeve.
Power On
3.3
CW0100 outdoor CPE is powered with POE. CPE provides standard POE power interface
conformed to IEEE 802.3af standard. The 4, 5 (+), 7, 8 (-) wire have direct current. Before
power on, test whether there is voltage output and whether voltage output is inverse with
multimeter.
Power on CW0100 CPE with POE supply:
1. Connect DATA IN port of POE adaptor to one of a switch port with Ethernet cable.
2. Connect one end of grounding wire to PE terminal of POE adaptor and fasten it, the
other end of grounding wire connect to grounding device.
3. Connect DATA&POWER OUT port of POE adaptor to POE port of CW0100 with
Ethernet cable.
Place POE adaptor and switch in the room, which is shown in Figure 3-13.
