22
Figure 5-2: TDD Quick Setting
Table 5-1: Quick Setting
Parameter Name
Description
carrierBwMhz
The bandwidth used by the eNB, as pre-planned by the operator.
Options are 5 MHz, 10 MHz, 15 MHz, or 20 MHz.
EARFCN
The absolute radio frequency channel number, assigned by the
operator. Range: 38750 - 39250
earfcnDI (MHz)
The eNB’s operating frequency, assigned by the operator. The
range depends on the eNB model.
PCI
Physical Cell Identification (PCI), assigned by the operator.
Range: 0 to 503.
PCI is Layer 1 identity, an essential configuration parameter of a
radio cell that uniquely identifies each cell site in the wireless
network. PCI planning is crucial for quality of service (QoS).
Cell ID
The logical cell identification (ID) randomly assigned to this eNB.
Range: 0 to 268,435,455.
MME PORT
The MME port of the IP address
PLMN
The numerical identifier for the operator’s Public Land Mobile
Network (PLMN) for this cell. Must be a 5- or 6-digit number.
Assigned by the operator.
TAC
Tracking Area Code (TAC) where the eNB is located. The TAC is
used to determine the range of the paging information. The
operator can use a number between 0 to 65,535. The default is 1.
subFrameAssignment
Downlink (DL) and uplink (UL) subframe configuration, either 1 or
2, where:
Summary of Contents for Neutrino-224
Page 1: ...Neutrino 224 Indoor 2x125mW FDD TDD eNodeB Installation Guide December 2018 Version 1 7...
Page 20: ...20 Figure 4 7 FDD eNB GUI Home Page Figure 4 8 TDD eNB GUI Home Page...
Page 47: ...47 Figure 5 24 LTE Neigh Freq Settings 1 of 2 Figure 5 25 LTE Neigh Freq Settings 2 of 2...
Page 64: ...64 Figure 5 38 Cell ReSelection Parameter Figure 5 39 Additional Measurement Parameter...
