77
Table 5-31: Log Config
Parameter Name
Description
LTE log level (Figure 5-50):
L2 log level
L2 log level is not used in Release 2.x.x or later
RRC log level
RRC log level
oamAdapter log level
OAM adapter log level
RRM log level
RRM log level
SON log level
SON log level
OAM log level
OAM logs log level
phyTraceSubsystemConfig (Figure 5-50):
Subsystem
Select the subsystem.
streamToRemoteHost
Indicates whether logs from this subsystem will be logged to
the remote host
logToFile
Indicates whether logs from this subsystem will be logged to
the local file
forwardPort
User Datagram Protocol (UDP) port number used for remote
logging
separateLog
Indicates whether to log this subsystem separately. Needed
only when logToFile is
true
. For LTE_L1 and LTE_L2 this must be
true.
logFileSize
The size of a single log file. No checking is done on
whether the file system has enough free space to hold the logs.
logFileCount
Number of logs, including the current one, to keep. Is used for
rotation.
logFileComp
Compression level for the log files. Recommend leaving the
default value.
mmsgCount
Number of messages to pull at a time using
recvmmsg
.
Recommend leaving the default value.
phyTraceConfig (Figure 5-51):
forwardIPAddr
Set the IP address of the remote host.
collectStats
If set to false, stats of the log system will not be collected
l1LogType
Determines whether to log l1 to binary or just pcap or to
include all headers(pcap/eth/ip/udp). Only ALL_HEADERS is
supported currently.
wiresharkEnabled
Indicates whether or not wireshark capture is enabled for
signaling(UU/S1AP/X2AP).
phyTraceNetworkCaptureConfig (Figure 5-52):
Interface
Name of the network interface
PcapFilter
Filter to apply while capturing Packet Capture (
pcap)
packets.
Any updates to the filter will take effect the next time the
interface is enabled again.
Example: sctp port 36412 or sctp port 36422
Range: 1 to 256 digits
Summary of Contents for Neutrino-224
Page 1: ...Neutrino 224 Indoor 2x125mW FDD TDD eNodeB Installation Guide December 2018 Version 1 7...
Page 20: ...20 Figure 4 7 FDD eNB GUI Home Page Figure 4 8 TDD eNB GUI Home Page...
Page 47: ...47 Figure 5 24 LTE Neigh Freq Settings 1 of 2 Figure 5 25 LTE Neigh Freq Settings 2 of 2...
Page 64: ...64 Figure 5 38 Cell ReSelection Parameter Figure 5 39 Additional Measurement Parameter...
