| 38 |
EN
3.5 Intended use
Diamond drill
The diamond drill can be used for both dry and wet
drilling.
The diamond drill is designed for both hand-held
operation, and for use with a drill stand (here it is
possible to operate the drill with a water extraction
kit).
NOTE
The diamond drilling machine is not suitable for
overhead drilling in wet mode. For hand-held
drilling, the centring suction plate and a suitable
water suction appliance (e.g. BAIER special dust
extractor) is to be used.
The diamond drill is intended to be used for drilling
and cutting holes for junction boxes in mineral
materials such as concrete, reinforced concrete,
clay bricks, lime-sand blocks or undressed stone.
The following materials may
not
be drilled: wood,
metal and glass, etc.
Observe the relevant regulations in your
country for the materials to be machined and
extraction.
4
Before Starting Work
To ensure safe working with the diamond drill, the
following points must be observed before each use:
•
Read through all safety instructions and
warnings in this instruction manual.
•
Wear protective clothing such as hard hat, face
protection or safety goggles, safety gloves,
suitable half-face filter mask, slip-resistant
safety footwear and if necessary an apron.
•
The voltage on the rating plate must be identical
with the mains voltage.
•
Before each use, check the machine,
connection cable, plug, secure fit of the diamond
core drill bit and, if applicable, the fixing of the
drill stand.
•
Always note follow the thread dimension of the
diamond core drill bit arbour. The thread of the
diamond core drill bits must fit on the thread of
the diamond drill (G½″ internal thread or 1¼″
UNC external thread) without any clearance.
Do not use reducers or adaptors for fitting the
diamond core drill bits.
•
Visually inspect the condition of the diamond
core drill bit.
NOTE
Damaged diamond core drill bits may not be used
and must be replaced immediately.
•
Only use the diamond core drill bits
recommended by OTTO BAIER GmbH for the
respective area of use.
NOTE
The diamond core drill bit can become irreparably
damaged by overheating or jamming in the drill
core hole (“Handling Diamond Core Drill Bits” on
If harmful dust is produced during the work, a
suitable dust extractor must be connected to the
diamond drill (e.g. BAIER special dust extractor).
•
Connect a suitable dust extractor / water
extractor.
•
The additional handle must be tightly screwed
onto the drill for hand-held drilling.
3
Checking the personal protection switch
DANGER
Risk of injury due to electric shock.
Î
The personal protection switch PRCD must be
checked each time before the wet diamond dill
is started up (see below). If the PRCD does not
trip during the test or if it repeatedly switches
off when the wet diamond drill is switched on,
the wet diamond drill together with the PRCD
personal protection switch must be examined
by a qualified electrician.
•
With the mains plug plugged in and the wet
diamond drill switched off, press the −ON−
(RESET) button (2). The red indicator light (1)
must light up.
•
Press the −OFF− (TEST) button (3). The PRCD
must switch off, i.e. the red indicator light (1)
goes out.
•
Press the −ON− (RESET) button again (2).
The wet diamond drill must now be able to be
switched on.
•
If the PRCD does not trip during the test or if it
repeatedly switches off when the wet diamond
drill is switched on, the wet diamond drill
together with the PRCD personal protection
switch must be examined by a qualified
electrician.
Summary of Contents for BDB 825
