| 24 |
EN
DANGER
Risk of injury due to electric shock.
Î
Disconnect the mains plug before carrying out
any work (e.g. changing the stirrer) on the high-
speed mixer.
DANGER
Risk of poisoning due to toxic gases.
Risk of burns and fire due to flammable gases.
Î
Do not process liquids or materials with unknown
hazard potential.
Î
Observe the instructions for use issued by the
manufacturer of the material to be stirred.
Î
When processing plastics, paints, varnishes and
similar materials, do
not
work near flammable
gases or materials.
•
Place the container with the material to be stirred
in a firm, stable position.
•
Choose stirrers suitable for the material to be
mixed.
•
1
Mount the stirrer, screw the stirrer into the tool
holder (1) up to the limit stop:
•
Switch on the machine at the ON / OFF switch
and set the speed or gear; if empirical values are
not available, start with the lowest speed or the
1st gear.
•
Select the gear:
f
1
/
2
Set the speed (see technical spec-
ifications, page 22) at the gear change
knob (2).
NOTE
Changing gear while the machine is running can
cause damage to the drill.
Wait for the machine to completely stop.
5
Operation and Control
•
Switch on the PRCD switch; only for the
BSM 2868 – 110 V highspeed mixer.
•
Immerse the stirrer in the material to be mixed.
•
1
Use the ON / OFF switch (5) to start the motor.
•
In case of low-viscosity media, immerse the
stirrer completely and start.
f
Increase the speed if necessary.
•
In case of high-viscosity media, immerse the
stirrer by half and at an angle and start.
f
Select a low speed.
•
After ending the mixing process, pull the stirrer
out of the material to be mixed as the stirrer runs
down.
6
Cleaning
DANGER
Risk of injury due to electric shock.
Î
Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The machine must be cleaned after each work
session.
•
Carefully clean the machine and blow out with
compressed air.
•
Ensure handles are dry and free from grease.
7
Maintenance
DANGER
Risk of injury due to electric shock.
Î
Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The high-speed mixer must be serviced at least once
a year. Further, servicing will be necessary depend-
ing on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may carry out
maintenance of the machine. Also ensure that origi-
nal BAIER spare parts and original BAIER accesso-
ries only are used.
8
Disposal
Recycle the machine and its packaging in
an environmentally friendly way in accord-
ance with the provisions applicable in your
country.
Summary of Contents for BSM 2868
Page 3: ...3 2 BSM 2868 110 V 230 V 1 BSM 2868 110 V 230 V 3 BSM 2868 110 V ON RESET OFF TEST...
Page 49: ......
Page 50: ......
Page 51: ......
