17
17
ELECTRICAL
Power Specifications
Your tool is wired for 220 volts, 60Hz alternating current. Before connecting the tool to the power
source, make sure the machine is cut off from power source.
Before switching on the power, you must check the voltage and frequency of the power to see if
they meet with the requirement. The allowed range for the voltage is ±5%, and for the frequency
is ±1%.
IMPORTANT:
To achieve proper performance and prevent damage, the power supplied
to this machine must be 220VAC ±5% (209VAC to 231VAC). Failure to comply will damage the
machine and void the warranty. If needed, contact Baileigh Industrial at 920-684-4990 to
purchase a Buck Boost transformer. The service personal will be able to assist in placing the
order for the transformer or provide specifications so that you will be able to obtain the proper
transformer for your application.
Buck-Boost transformers are small single phase
transformers designed to lower (buck) or raise (boost) line voltage from 5-20%.
Considerations
•
Observe local electrical codes when connecting the machine.
•
The circuit should be protected with a time delay fuse or circuit breaker with a amperage
rating slightly higher than the full load current of machine.
•
A separate electrical circuit should be used for your tools. Before connecting the motor to the
power li
ne, make sure the switch is in the “OFF” position and be sure that the electric current
is of the same characteristics as indicated on the tool.
•
All line connections should make good contact. Running on low voltage will damage the
motor.
•
In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is equipped with an electric cord
having an equipment-grounding conductor and a grounding plug. The plug must be plugged
into a matching outlet that is properly installed and grounded in accordance with all local
codes and ordinances.
CAUTION:
HAVE ELECTRICAL UTILITIES CONNECTED TO MACHINE BY
A CERTIFIED ELECTRICIAN!
Check if the available power supply is the same as listed on the machine nameplate.
WARNING:
Make sure the grounding wire (green) is properly connected
to avoid electric shock. DO NOT switch the position of the green grounding wire if
any electrical plug wires are switched during hookup.
Summary of Contents for 1000568
Page 12: ...10 10 4 1 2 3 3...
Page 16: ...14 14 OVERALL DIMENSIONS...
Page 31: ...29 29 PARTS DIAGRAM...
