28
28
Checking Machine Accuracy
To achieve and maintain accurate bends on the Baileigh BB-9616M magnetic brake, the
working surface of the bending beam and the bending edge of the clamp bar need to be
straight. Both of these surfaces must also be parallel to each other. This can be checked
periodically with a precision straight edge.
Checking the Gap
1. Raise the bending leaf up to a 90° position as shown in (fig. 20).
2. Secure with the locking collar (fig. 21) on the leaf angle indicator arm.
3. Set the gap between the working surface of the bending leaf and the edge of the clamping
bar to .039” +/- .008” by using the clamp bar adjusters (fig. 22).
4. The adjuster knobs should be set the same at each end of the clamp bar.
figure 21
figure 20
figure 22
.039"
90°
Summary of Contents for 1000568
Page 12: ...10 10 4 1 2 3 3...
Page 16: ...14 14 OVERALL DIMENSIONS...
Page 31: ...29 29 PARTS DIAGRAM...
