20
20
Item Description
A
Bending Cylinders. Moves the ram, (Y Axis) down and up. Internal stops are used to
set the depth of bend.
B
Upper Ram Plate. Holds the bending punch and moves down to press the punch into
the material and then the die to create the form of the punch and die set.
C
Control Pendent Swing Arm. Supports the control pendent and allows for some
movement to position the pendent.
D
Electrical Enclosure. Housed the electrical operating components and connections.
E
Control Pendent. Using the controller along with the buttons and switches, operator
sets the parameters and operating conditions to be used during the bending process.
F
Light Curtain Emitter. Send out 8 light beams to the receiver to create the safety
curtain in front of the bending opening.
G
Lower Die Clamp. Holds the die in position under the punch.
H
Foot Controls. Used to operate the actual bending cycle once the parameters and
operating conditions have been set.
I
Front Material Supports. Holds the material before and after the bend. May be
adjusted wider apart or closer together as needed. Operator should make efforts to
center the bend at or near the center of the press for all bends.
J
Lower Die. The standard die is four sided with 7 bending V’s.
K
Light Curtain Receiver. Receives the 8 light beams from the emitter to create the
safety curtain in front of the bending opening.
L
Bending Punch. Presses the material into the lower die to create the specific bend
shape in the material.
M
Bending Punch Clamps. Secures the upper die to the ram. The quick release style
allows for fast tooling changes.
N
Main Motor. Powers the hydraulic pump and in turn the hydraulic system.
O
Hydraulic Pump. Provides the hydraulic fluid flow to the hydraulic system.
P
Hydraulic Manifold and Valve Assembly
Q
Main Pressure Gauge.
R
Depth of Bend Motor (Y Axis). This motor is used to change the depth stops located
inside of the ram cylinders. This changes how far down the ram will travel during the
bending cycle.
S
Hydraulic Tank Level / Temperature Gauge. Holds the hydraulic fluid. The gauge
indicates the fluid level and temperature. Just above the gauge on the top of the tank
is the fill cap.
T
Hydraulic Tank Drain Valve. The ball valve used to drain the hydraulic fluid each year
during normal service.
U
Back Gauge Support Arm. Holds the material stops used to set the depth to which the
material is inserted into the press before bending. The support arm travels forward
and aft to set the gauge distance. Fine adjustment is done on each of the material
stops separately.
Summary of Contents for BP-3305CNC
