35
35
a. The CP line is a bend counter line. If 0 (zero) is entered for the PP value, the CP line
will continue to count each bend cycle as one bend. If the PP line has a value, the CP
number will count down from the programmed value to 0 (zero) to complete the
counted parts.
13. Press the
Enter key. This will enter the value if any into the CP line and move the
highlight to the next line. The DLY line.
14. Enter the value, if needed, for a delay to occur before the back-gauge will retract away from
the work piece. This will allow the punch to move deeper into the bend before the back-
gauge move back away from the work piece. This value will be displayed in the bottom line
of the screen.
15. Press the
Enter key. This will enter the value into the DLY line and move the
highlight to the next line. The HT line.
16. Enter the value needed for the Hold Time (HT). Generally, start with a value of 1.5 seconds
and fine tune the number with experience for the specific bend and material. This value will
be displayed in the bottom line of the screen.
17. Press the
Enter key. This will enter the value into the HT line and move the
highlight to the next line. The ST line.
18. When the setup is complete, press the
right arrow key to enter the step parameter setup
screen. This will allow for setting the parameters for the first station.
19. Th
e “Program2 1/xST” screen will appear with the
“XP” line highlighted. This line is the
“PROGRAMMED” position of the back-gauge, (X
axis).
20. Enter the value desired of the position of the back-
gauge (XP). This value will be displayed in the
bottom line of the screen. This is the line with the
pencil
symbol.
21. Press the
Enter key. This will enter the
value into the XP line and move the highlight to the
next line. The YP line.
22. Enter the value desired of the position of the depth of bend (YP). This value will be displayed
in the bottom line of the screen.
23. Press the
Enter key. This will enter the value into the YP line and move the
highlight to the next line. The DX line.
Summary of Contents for BP-3305CNC
