19
19
Machine Base
The machine base supports the saw bow, the vise, the coolant pump, the hydraulic unit, the bar
stop, the swing arm, and the roller for supporting material.
Swivel Saw Head
Angles can be cut up to 60° (Right) with the vise left of the
blade and 45° (Left) with the vise right of the blade.
Unlock the rotating saw head by pushing the miter lock lever
(R) to the left and by retracting stop pin (AF). Rotate the saw
head to the desired angle as shown on the angle indicator
(Q). Lock the saw head by pushing the lock lever (R) to the
right (as shown).
Note:
Pin (AF) has stops at 0° & 45° (Right)
NOTICE:
Check that the saw blade clears all parts of
the vise assembly before cutting. The blade can strike
parts of the assembly (especially during miter cuts) if
not properly adjusted. Make sure saw bow is in a
down or horizontal position when moving or mitering
to avoid tipping over machine.
figure 3
AF
R
figure 2
Q
figure 1
Summary of Contents for BS-350SA
