39
39
OPERATION
1. Select and set the proper blade speed for the material being cut.
2. Connect power to the saw.
3. Reset the
“E”-Stop button.
4. Turn the feed rate knob
0
2
4
6
8
clockwise (cw) to close.
5. Turn the cylinder valve
ON
to the “ON” clockwise (cw) position.
6. Adjust the blade guide assemblies for the size of the material.
7. Use the handle to raise the saw bow to approximately 45°.
8. Place material onto the base of the vise, set the material stop, and clamp the material
securely.
9.
Start the saw motor by pressing the Black “O” start button.
10. Slowly open the feed rate knob
0
2
4
6
8
counterclockwise (ccw) to start the bow descent.
11. Start the coolant flow (slowly) by turning the brass valve counterclockwise (ccw.)
12. When the cut is finished, the saw motor and coolant pump will shut off.
13. Raise the saw bow for the next cut.
14.
Turn the cylinder valve to the “OFF” counterclockwise (ccw) position to stop the bow
descent.
15. Advance the material in the vise and secure it.
16.
Press the Black “O” start button.
17. Turn the cylinder valve
ON
to the “ON” clockwise (cw) position to start the bow descent.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
NEVER operate saw without blade guards in place.
Summary of Contents for BS-712MS
