40
40
LUBRICATION AND MAINTENANCE
Daily Maintenance
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Do a general cleaning by removing dust and metal chips from the machine.
•
Inspect the saw blade for wear.
•
Top off the coolant tank.
•
Clean the lubricating coolant drain screen.
•
Check that the blade guards and emergency stop button are in good working order.
•
When through using machine, raise the saw head to its up position and release some
•
tension on the saw blade.
Weekly Maintenance
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
•
Thoroughly clean the machine.
•
Wipe and re-grease the vise screw and sliding surfaces.
•
Remove chips from inside the guard housing for the saw blade.
•
Use compressed air to clean the blade guides and guide bearings.
Monthly Maintenance
•
Check the blade guide bearings for wear. (replace if necessary)
•
Tighten any loose bolts or screws on the gear motor, pump, and safety switches.
•
Clean coolant tank
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Summary of Contents for BS-712MS
