53
53
6. Dull blade.
7. Speed incorrect.
8. Blade guide assembly loose.
9. Blade guide bearing
assembly loose.
10. Blade tracks too far away
from wheel flanges.
6. Replace blade.
7. Check manual for
recommended speeds.
8. Tighten.
9. Tighten.
10. Re-adjust tracking per
instructions in this manual.
Saw Motor Does Not
Stop When Cut is
Finished
1. Actuator on cylinder does not
contact switch properly.
1. Re-adjust actuator or switch.
Coolant Motor Does Not
Run with Band Saw
Motor
1. Coolant motor M2 damaged.
1. Replace M2 motor.
Blade Cuts (Rough)
1. Too much speed or feed.
2. Blade is too coarse.
1. Reduce speed and feed.
2. Replace with a finer blade.
Blade is Twisting
1. Cut is causing the blade to
bind.
2. Too much blade tension.
1. Decrease the feed pressure.
2. Decrease the blade tension.
Unusual Wear on
Side/Back of Blade
1. Blade guides worn.
2. Blade guide bearings not
adjusted properly.
3. Blade guide bearing bracket
is loose.
1. Replace blade guides.
2. Adjust as per operator’s
manual.
3. Tighten bracket
Motor Running too Hot
1. Blade tension is too high.
2. Blade is too coarse for work
(especially pipes).
3. Blade is too fine for work.
(Heavier, soft, materials.
4. Gears need lubrication.
5. Idler wheel needs lubrication
1. Reduce tension on blade.
2. Use finer blade.
3. Use coarser blade.
4. Check oil bath.
5. Oil bearing/shaft on idler
wheel.
Summary of Contents for BS-712MS
