14
14
Setup and Assembly
Read and understand all assembly
instructions before attempting assembly. Saw
must remain unplugged from power source during
assembly procedures.
Shipping Contents
Refer to Figure 4.
1 Scroll saw (not shown)
4 Leveling feet with hex nuts
2 Lower blade holders
1 Foot pedal assembly
1 Dust port
1 Blade rack
5 Blades, skip type (not shown)
4 Rubber washer – (HP5)
2 Button Head Socket Screws (not shown)
1 Operator’s manual (not shown)
1 Product registration card (not shown)
Figure 4: Contents (not to scale)
Tools Required for Assembly
• 14mm open-end wrench (for foot pads)
• 3mm hex wrench (for blade guide)
• 4mm hex wrench (for blade rack)
Unpacking and Clean-up
1. Remove all contents from shipping carton.
Remove protective coating from the table using a
soft cloth moistened with a solvent. (Do
not
use
acetone, gasoline, or lacquer thinner for this
purpose, as these will damage painted and plastic
parts.)
2. Inspect contents for shipping damage or missing
parts. Report any damage or part shortages to
your distributor. (Note: Check saw for any pre-
installed parts before reporting part shortage.)
