23
23
Figure 23: Straight Cutting
Figure 24: Outside Curve Cutting
For fretwork (inside cutting):
1. Drill pilot holes in workpiece just large enough for
blade insertion.
1. Release clamp lever (D, Figure 25) and raise arm.
2. Guide blade through pilot hole in workpiece.
3. Lower arm and tighten clamp lever (D).
4. Hold workpiece tightly against table and turn on
saw. Set speed using variable control knob.
5. Smoothly guide workpiece into blade, using light
pressure. Avoid coming to a complete stop while
cutting.
Figure 25: Fretwork Cutting
Maintenance
Always unplug scroll saw from
power before performing maintenance. Failure to
comply may result in serious personal injury.
General Maintenance
Clean wood dust from the saw frequently, using a
vacuum or compressed air, or damp cloth. Use a soft
bristle brush for crevices.
Use proper eye and respiratory
protection if using compressed air.
Keep the table clean. Periodically apply a light coat of
paste wax or spray protectant to the table to prevent
rust and maintain a smooth surface.
When finished cutting, release blade from upper clamp
to remove unneeded tension on clamp spring.
Remove blade if saw will be stored for longer periods.
Periodically inspect the prongs of the lower spring
plate (see E, Figure 13). Bend upward slightly if
needed to ensure a firm grip upon lower blade holder.
