26
26
Using the stop bar
1. Cut off the first length from the clamped piece part.
2. Unclamp the piece part.
3. Slide the piece part forward until it reaches the tip of the stop bar (C).
4. Clamp the piece part.
5. Proceed with the cutting cycle.
Cutting Operation Cycle
1. Set the miter cut angle.
2. Open the vise jaws.
3. Load and clamp the piece part.
4. Adjust the bar stop for cutting length.
5. Press button (A) to turn power on to the saw. (Green light
will be lit).
6. Set the coolant switch (B) to on.
7. Grasp the feed handle (C).
8. Press the trigger switch (D) to start blade motor.
9. Pull down the feed handle (C) applying a steady and constant
pressure.
10. After cut-off, raise feed handle slowly.
11. Release the trigger switch (D) to stop the blade motor.
12. Use vise lever to open the jaws.
13. Remove or advance the piece part forward for next cut.
14. To turn off machine power press the stop button (E)
15. To stop machine in an emergency situation, press the
EMERGENCY STOP button (F).
16. Before restarting machine, emergency stop button must be reset with a clockwise (cw) twist.
NOTICE: Do not allow the saw to slam back up to the start position. Doing so will cause
damage to the pivot block and the weight of the motor will cause damage to the gear case
adaptor over time.
E
F
B
A
D
C
