20
20
ADJUSTING BELT TENSION
Use the two bolts to adjust the belt tension (Fig. 8).
When achieved proper position of adjustment tighten
bolts to hold in place.
FEED ROLL SPEED RATE
The rate of speed is transmitted by shift gears located
in gear box.
The shift gear handle (Fig. 9) performs with three
different methods of speed by using the shift handle to
pull or push.
Position A: feed roll is functioning on 20-FPM speed
rate.
Position B: feed roll is functioning on 0-speed rate.
Position C: feed roll is functioning on 16-FPM speed
rate.
Note: Only change gears when the motor
is running.
Fig. 8
Fig. 9
Fig. 10
Summary of Contents for IP-156
