16
16
MATERIAL SELECTION
When selecting materials keep these instructions in mind:
•
Material must be clean and dry. (without oil)
•
Material should have a smooth surface so it processes easily.
•
Dimensional properties of material must be consistent and not exceed the machine capacity
values.
•
Chemical structure of material must be consistent.
•
Buy certificated steel from the same vendor when possible.
LUBRICATION AND MAINTENANCE
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
•
There are 7 grease fittings on the machine. Grease these fittings every month with two
pumps from a standard grease gun.
•
Check for any worn or damaged parts and replace immediately.
•
Check and fill oil cup as needed. Use AW-46 hydraulic oil.
Note
: Proper maintenance can increase the life expectancy of your machine.
CAUTION:
It must be determined by the customer that materials being
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Summary of Contents for B8935
