9
9
35.
Do not
operate this machine if the gap between the moving abrasive belt, disc or wheel and
the adjacent face of the work rest (or table) will permit passage of the work piece through the
gap (nip point).
36.
Never
position the work rest table at an acute angle between the top of the work rest table
and the moving belt or wheel. Doing so will create "nip point" that can cause serious injury
should an operator body part become entangled (pulled into) the nip point created by this
acute angle.
37.
Do not
operate the equipment, or allow others to operate the equipment without proper
training in these and other rotating machinery safety requirements.
38.
Correct equipment or safety problems immediately
. Do not operate the equipment when
it requires maintenance, or correction.
39.
Install and use high quality abrasive belts, wheels, discs, media, etc.,
as appropriate to
your machine. Understand and follow the operating requirements provided by the
manufacturer of these materials.
In the event of incorrect operation or dangerous conditions, the machine can be
stopped immediately by pressing the
STOP
button.
WARNING:
Certain alloys such as titanium may create conditions where
grinding debris can accumulate in a tight gap creating a potential fire hazard. When
in doubt consult with your safety officer. Failure to observe this warning may result
in the work piece or other item being caught in this gap, and/or being forcibly
ejected. Failure to heed this warning may cause serious bodily harm to the operator
and/or bystanders. NEVER USE THIS EQUIPMENT IF YOU ARE NOT PROPERLY
TRAINED IN ITS OPERATION and/or SAFE USE! IF IN DOUBT STOP and ASK FOR
GUIDANCE!
Summary of Contents for BG-260-3-110
Page 25: ...23 23 PARTS DIAGRAM...
Page 29: ...27 27 NOTES...
Page 30: ...28 28 NOTES...
Page 31: ...29 29 NOTES...
