17
17
OPERATION
Initial Operation
1. Start the motor by pressing the ON button.
The belt should rotate smoothly with the
belt traveling downward (A) past the
grinding area. If either of these conditions
is not met immediately turn the machine
OFF.
a. If the abrasive belt does not remain
centered on the contact wheel while
the belt is moving use the tracking
adjustment (B) on the upper left
side of the machine to track the
belt. Turning this control CW to
cause the belt to track to the left,
conversely turn the control CCW to
cause the belt to move to the right.
b. If the belt runs in reverse (upward), you must correct this unsafe condition by
changing the main drive motor rotation direction.
2. Reverse the motor direction of a single phase motor by reversing leads within the metal
wiring box (C) located on the motor. Follow the diagram or other instructions on the actual
motor label. These diagrams are usually on the inside of the motor connection cover.
3. If the abrasive belt tensions, and tracks properly, but has excessive vibration turn the
machine OFF and call the factory for assistance.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials, make sure they are properly supported.
WARNING:
Disconnect the machine from its power source opening any
covers or making any repairs. A competent electrician should perform all electrical
work.
B
A
C
Summary of Contents for BG-260-3-110
Page 25: ...23 23 PARTS DIAGRAM...
Page 29: ...27 27 NOTES...
Page 30: ...28 28 NOTES...
Page 31: ...29 29 NOTES...