17
17
Changing the Disc
1. Shut off the machine, making sure the driving
wheel has completely stopped.
2. Remove the working table assembly (
11
).
3. Peel off the used disc which utilizes a hook and
loop method of attachment as shown in (fig. 5).
4. Place a new disc onto the back plate, making
sure to keep it centered. Press to ensure good
contact.
5. Replace the working table assembly (
11
).
Angular Adjustment for Body Frame
1. Shut off the machine, making sure the driving
wheel has completely stopped.
2. Remove the working table assembly (11).
3. Peel off the sanding / grinding disc.
4. There are (four) socket head cap screws that
need to be loosened in order for the body frame
to pivot. They can be accessed through the two
holes in the back plate. (Note: You may have to
provide clearance holes through the loop material
for inserting the allen wrench.
5. After setting the desired angle, tighten the (four) hex cap screws.
6. Replace the sanding / grinding disc and the working table assembly (11).
figure 6
figure 7
