42
42
Control The depth of Cutting
The cutting depth scale is a combination of inch/metric
scale (A). The cutting range is from 0 to 8”. The
distance between upward or downward of driving
handle
(B) is 0.059” one complete turn. The maximum
depth of cut on full width
planning is 1/8”. A limiter (C) is
provide to limit the depth of cut. If the workpiece to be
cut is less than 8” the allowable maximum depth of cut
no more than 1/4” in one pass.
Parts Lubrication Required
No. Descriptions
Grease
Oil
1.
Lead Screw
Yes
No
2.
Gear Box
No
Yes
3.
Chain
Yes
No
4.
Chain
Yes
No
5.
Chain
Yes
No
6.
Bracket
No
Yes
7.
Column
No
Yes
Lead Screw is used to adjust the table up or
down
All chains must be lubrication regularly.
After 30 hours or more of work the lubrication of
bracket must be added.
The machine comes equipped with four columns.
It is important to always keep them lubricated.
To ensure maximum performance always keep
the sliding rollers of table lubricated.
Summary of Contents for IP-2008-HD
