22
22
TABLE ROLLERS
Adjustment Height Range
0
– 0.023” (0 – 0.6mm)
The height of the table rollers will vary, depending
on the condition of the wood you intend to plane.
When planing rough cut stock, set the rollers high
to keep the lumber from dragging along the bed.
When planing milled lumber, set the rollers low to
help minimize snipe (gouging at the ends of the
workpiece).
To adjust the table rollers:
1. Loosen the lock nut on the adjusting knob. (Fig. 8).
2. Turn the knob to adjust the roller to desired height.
3. Tighten the lock nut.
Fig. 8
Fig. 7
Table Roller
Table
Feed Direction
0
– 0.023”
(0
– 0.6mm)
Summary of Contents for IP-2511-HD
