6
6
HIGH VOLTAGE
USE CAUTION IN HIGH VOLTAGE AREAS. DO NOT
assume the
power to be off.
(FOLLOW PROPER LOCKOUT PROCEDURES)
SAFETY PRECAUTIONS
Wood working can be dangerous if safe and proper operating procedures are not followed. As
with all machinery, there are certain hazards involved with the operation of the product. Using
the machine with respect and caution will considerably lessen the possibility of personal injury.
However, if normal safety precautions are overlooked or ignored, personal injury to the operator
may result.
Safety equipment such as guards, push sticks, hold-downs, feather boards, goggles, dust
masks and hearing protection can reduce your potential for injury. But even the best guard won’t
make up for poor judgment, carelessness or inattention.
Always use common sense
and
exercise
caution
in the workshop. If
a procedure feels dangerous, don’t try it.
REMEMBER:
Your personal safety is your responsibility
.
1.
FOR YOUR OWN SAFETY, READ INSTRUCTION MANUAL BEFORE OPERATING THE
MACHINE.
Learn the
machine’s application and limitations as well as the specific hazards.
2.
Only trained and qualified personnel should operate this machine.
3.
Kickback.
Become
familiar with the term
“Kickback”
and how it occurs before operating
this planer. Kickback happens when the piece part is thrown towards the operator at a high
rate of speed with the potential for serious injury.
4.
Kickback Zone.
The path directly behind the end of the in-feed table is referred to as the
“Kickback zone”.
NEVER
stand or allow others to stand in this area while the machine is
running. Position yourself to one side of the machine while the planer is running.
5.
Reaching Inside Planer.
To avoid serious personal injury from rotating knives,
NEVER
remove guards or reach inside the planer while it is connected to power. Always Follow
proper lockout /tagout procedures.
WARNING:
FAILURE TO FOLLOW THESE RULES MAY RESULT IN
SERIOUS PERSONAL INJURY
Summary of Contents for IP-2511-HD
