33
33
Tailstock Controls
The tailstock primary use is for holding centers and drill chucks.
Turning the handwheel advances or retracts the barrel in the
tailstock. The graduated dial on the handwheel is adjustable.
The top lock lever locks the tailstock barrel in place. The side
lock lever locks the tailstock in place on the lathe bed.
TEST RUN
1. Before preceding with a test run, check that the machine is securely mounted in place and
that you have read and understand the Operator Safety Instructions at the beginning of this
manual.
2. Make sure the machine is properly grounded and the Fwd/Rev handle is in neutral.
3. Inspect the lathe bed and rest of the machine for any tools and loose parts. Check that all
guarding is in place, and that nothing is obstructing the movement of the chuck.
4. Check that the gearbox and carriage sight glasses show adequate oil levels.
WARNING:
Before powering up machine, make sure Fwd/Rev. handle is
in the center (neutral) position.
All machinery poses a potential for danger when being operated. Accidents result
from lack of machine knowledge and failure to pay attention. Always be cautious and
alert to the potential for serious injury. Follow safety rules and precautions to lessen
the chances of an accident.
Top Lock Lever
Side Lock Lever
Pin will engage hole when
In neutral position.
Summary of Contents for PL-1340E-1.0
Page 48: ...45 45 ELECTRICAL DIAGRAM...
